EPC42
The EPC42 is the link between the IM7/x potentiostat and the power and auxiliary potentiostats or electronic loads. One EPC42 card can address up to four PP/EL/XPOT devices sequentially. Up to four EPC42 cards can be installed in a IM7 and up to eight EPC42 cards in a IM7x potentiostat. In total, a IM7x series potentiostat can be simultaneously connected with up to 32 external PPs/ELs, which can be controlled sequentially.
Packing List
EPC42 extension card
Installation
If the EPC42 card is purchased together with a basic device, it is already installed in the IM7/x system. Upgrading an IM7/x with EPC42 cards is very easy, as the cards only need to be inserted into the expansion slots provided. See IM7 Chapter for further information.
Note
The EPC42 plug-in card requires an expansion slot with a width of 4TE (corresponds to approx. 20mm). When upgrading, a new, smaller cover panel may be required for the remaining slots. This can be ordered as an accessory.
Specifications
Channels |
4 |
|
Sockets |
4x Lemosa EGG.1B.308.CLL |
|
Control Voltage Range |
±4 V |
|
Control Voltage Resolution |
16 bit |
|
Supported External Devices |
EL1002, PP212, PP222, PP242, XPOT2 |
|
Maximum EPC42 Cards Supported |
4 (16 Channels) 8 (32 Channels) |
IM7 IM7x |